Automation of an atomic force microscope via Arduino
Metadatos
Mostrar el registro completo del ítemAutor
Guerrero-Félix, Jesús Gerardo; López-Miras, Javier; Rodríguez Valverde, Miguel Ángel; Moraila-Martínez, Carmen Lucía; Fernández Rodríguez, Miguel ÁngelEditorial
Elsevier
Materia
Arduino Low-cost automation Atomic force microscope
Fecha
2023-09Referencia bibliográfica
J.G. Guerrero-Felix et al. Automation of an atomic force microscope via Arduino. HardwareX 15 (2023) e00447. [https://doi.org/10.1016/j.ohx.2023.e00447]
Patrocinador
MCIN/AEI PID2020-116615RA-I00; Consejeria de Universidad, Investigacion e Innovacion de la Junta de Andalucia EMC21_00008; Marie Curie Actions; Consejo Nacional de Ciencia y Tecnologia (CONACyT) A1S35536Resumen
The Atomic Force Microscopy is a very versatile technique that allows to characterize surfaces by acquiring topographies with sub-nanometer resolution. This technique often overcomes the problems and capabilities of electron microscopy when characterizing few nanometers thin coatings over solid substrates. They are expensive, in the half million dollar range for standard units, and therefore it is often difficult to upgrade to new units with improved characteristics. One of these improvements, motorization and automation of the measurements is very interesting to sample different parts of a substrate in an unattended way. Here we report a low cost upgrade under 60 $ to a Dimension 3000 AFM based on a control unit using an Arduino Leonardo. It enables to acquire dozens or hundreds of images automatically by mimicking keyboard shortcuts and interfacing the AFM PCI card.