Residual capacity assessment of reinforced concrete D-Regions affected by corrosion Hernández Montes, Enrique Fernández-Ruiz, Manuel Alejandro Carbonell Márquez, Juan Francisco Gil Martín, Luisa María Disturbed regions Reinforced concrete Corroded reinforcement Residual capacity Anchorage length Important note: The present paper work was sent to Construction and Building Materials on 15 April 2020 (it is currently under review). The repair and rehabilitation of Reinforced Concrete (RC) structures affected by the corrosion of their reinforcement is a complex task. The estimation of the residual structural capacity of corroded RC structures is becoming a crucial factor in the decision-making process of repair or demolition. Many researchers have studied the effects of reinforcement corrosion on the load capacity of RC beams (Bernoulli or B-Regions) but little attention has been paid to disturbed or D-Regions. This piece of work presents a procedure for the assessment of the residual structural capacity of D-Regions in RC members. The bond deterioration between steel and concrete, the reduction of the cross-sectional area of reinforcement, the deterioration of the concrete area of the cross-section and the softening of concrete has been taken into consideration. The accuracy of the method has been tested with experimental results which exist in relevant literature. 2020-07-01T07:09:56Z 2020-07-01T07:09:56Z 2020 info:eu-repo/semantics/article http://hdl.handle.net/10481/62795 eng http://creativecommons.org/licenses/by-nc-nd/3.0/es/ info:eu-repo/semantics/openAccess Atribución-NoComercial-SinDerivadas 3.0 España