Experimental investigation of rear flexible flaps interacting with the wake dynamics behind a squareback Ahmed body Muñoz-Hervás, José Carlos García-Baena, Carlos Jiménez-González, José Ignacio Lorite-Díez, Manuel Turbulent wakes Ahmed body Fluid-Structure Interaction Flow induced vibrations Experimental Fluid Mechanics We have conducted an experimental study on the use of rear flexible vertical flaps as adaptive solutions to reduce the drag of a squareback Ahmed body, and on the fluid–structure interaction mechanisms at the turbulent wake. To that aim, wind tunnel experiments were conducted to compare the performance of various configurations including the baseline body, the body with rigid flaps and with flexible flaps. These configurations were tested under different aligned and cross-flow conditions. The results reveal that the flexible adaptive devices effectively reduce the drag within for low values of the dimensionless stiffness quantified through the Cauchy number, 𝐶��𝑎��. Thus, the two-dimensional deformation of the flexible flaps, which undergo progressive inwards reconfiguration (with an averaged tip deflection angle of 𝛩�� ≃ 4◦), reduces the bluffness of the flow separation at the body base, thus shrinking the recirculation region. This reconfiguration leads to increased base pressure, resulting into a 8.3% decrease in the global drag, 𝐶��𝐷��, under aligned conditions. Similar drag reductions are observed under yawed conditions. Two regimes are identified in terms of the coupled fluid–structure dynamics. For low 𝐶��𝑎��, the passive reconfiguration of the flaps include small amplitude, periodic oscillations corresponding to the first free deformation mode of a cantilevered beam. Alongside these weak oscillations, the flaps are deformed guided by the changes in the value of the horizontal base pressure gradient, depicting bi-stable behavior which is caused by the synchronization between the Reflectional Symmetry Breaking (RSB) mode, typically present in the wake of three-dimensional bluff bodies, and the flaps deformation. For higher values of 𝐶��𝑎��, the flexible flaps deflect inwardly by about 𝛩�� ≃ 20◦ on average, but exhibit vigorous oscillations combining the first and second free deformation modes of a cantilevered beam. These large amplitude oscillations excite the flow separation at the model’s trailing edges, leading to significant fluctuations in the separated shear layers and a consequent 31% increase in the global drag. Under yawed conditions, the flaps responses for large values of 𝐶��𝑎�� are different due to the asymmetry of the corresponding recirculation region. 2024-05-06T09:12:08Z 2024-05-06T09:12:08Z 2024-05-04 journal article Journal of Fluids and Structures https://hdl.handle.net/10481/91420 10.1016/j.jfluidstructs.2024.104124 eng 127;104124 http://creativecommons.org/licenses/by-nc-nd/4.0/ open access Attribution-NonCommercial-NoDerivatives 4.0 Internacional Elsevier