Neocuproine-Based Sensitive Flow Injection Method for Mefenamic Acid Determination in Aqueous Solutions and Pharmaceutical Formulations Nayef, Ali Naser Hussain, Alaa Frak Taha, Dakhil Nassir Continues flow injection analysis mefenamic acid neocuproine análisis de inyección de flujo continuo ácido mefenámico neocuproína This study is a part of the PhD thesis of Ali Naser Nayef. Introduction: A novel and precise approach is presented for the mefenamic acid (MEF) estimation in pharmaceutical formulations and aqueous solutions, utilizing flow injection spectrophotometry. Similarly, this method demonstrates a high level of sensitivity and accuracy. Method: The suggested method is based on the reducing of Cu(II)-2,9DMP complex to coloured Cu(I)- 2,9DMP complex ,by two step of reaction. However, in the first step the reaction is occur between neocuproine and Cu(ΙΙ) to form colorless complex of Cu(II)-2,9DMP, then in second step mefenamic acid reduced the formed colorless complex to Cu(I)- 2,9DMP with yellow orange colour, Flow Injection Method were developed and validated. Results: The measurement of the optical density of the yellow-orange substances was conducted at a wavelength of 454 nm. The calibration graphs exhibit linearity within the specified concentration ranges of 1.00-80.00 μg/mL. The detection limit (LOD) is determined to be 0.360 μg/ mL, while the limit of quantification (LOQ) is found to be 1.093 μg/ mL. Conclusions: the proposed methodology exhibited notable attributes such as rapidity, sensitivity, and reliability, rendering it suitable for the accurate quantification of (MEF) in pharmaceutical formulations and aqueous solutions in various commercially available formulations. Introducción:Se presenta un enfoque novedoso y preciso para la estimación del ácido mefenámico (MEF) en formulaciones farmacéuticas y soluciones acuosas, utilizando espectrofotometría de inyección de flujo. Del mismo modo, este método demuestra un alto nivel de sensibilidad y precisión Método: Se basa en la reducción del complejo Cu (II)-2,9DMP a complejo Cu (I)-2,9DMP coloreado, mediante dos pasos de reacción. Sin embargo, en el primer paso se produce la reacción entre la neocuproína y el Cu (ΙΙ) para formar un complejo incoloro de Cu (II) -2,9DMP, y en el segundo paso el ácido mefenámico redujo el complejo incoloro formado a Cu (I) - 2,9DMP con color amarillo anaranjado, se desarrolló y validó el método de inyección de flujo. Resultados: La medición de la densidad óptica de las sustancias amarillo-naranja se realizó a una longitud de onda de 454 nm. Los gráficos de calibración muestran linealidad dentro de los rangos de concentración especificados de 1,00-80,00 μg / ml. El límite de detección (LOD) se determina en 0,360 μg/ml, mientras que el límite de cuantificación (LOQ) se encuentra en 1.093 μg/ml. Conclusiones: la metodología propuesta exhibió atributos notables como rapidez, sensibilidad y confiabilidad, lo que la hace adecuada para la cuantificación precisa de (MEF) en formulaciones farmacéuticas y soluciones acuosas en diversas formulaciones disponibles comercialmente. 2024-04-23T09:28:54Z 2024-04-23T09:28:54Z 2023-12-20 info:eu-repo/semantics/article Nayef, A.N.; Hussain, A.F.; Taha, D.N. Neocuproine-Based Sensitive Flow Injection Method for Mefenamic Acid Determination in Aqueous Solutions and Pharmaceutical Formulations. Ars Pharm, 65(1): 45-55 (2023). [10.30827/ars.v65i1.28908] 2340-9894 https://hdl.handle.net/10481/91068 10.30827/ars.v65i1.28908 eng http://creativecommons.org/licenses/by-nc-nd/4.0/ info:eu-repo/semantics/openAccess Attribution-NonCommercial-NoDerivatives 4.0 Internacional Universidad de Granada, Facultad de Farmacia