An energy balance snowmeltmodel in a Mediterranean site
Metadatos
Mostrar el registro completo del ítemMateria
Snow Evaporation Energy Balance Mediterranean
Fecha
2009-03-21Patrocinador
Water Institute of the Andalusian Regional Government (Junta de Andalucía), SpainResumen
This article describes the development and calibration of a mass and energy balance snowmelt point model for the southfacing
slope of the Sierra Nevada Mountains (Spain) and brings attention to snow processes taking place in a Mediterranean
site, especially to high evaporation rates. This mountain range has peaks rising to 3 500 m, and is located at latitude 37ºN,
surrounded by a mild Mediterranean climate. Energy balance over the snowpack is subjected to very changeable weather
conditions such as episodic strong low humidity winds, clear skies with very low nocturnal temperatures, intense solar radiation
and sudden increases in temperatures. We found the behavior of the snow to be extremely variable throughout the year,
especially in regards to melting cycles and evaporation. Simulations, based on snow water equivalent measurements, show that
during 2004-2005, 42% of the total snow precipitation evaporated. Only 124 mm of the 300 mm of snowfall collected at the
monitoring point actually melted. However, evaporation can range from 80% in December to 20% during the spring months
and from 20% to 40% between years. The variability of the balance of energy fluxes acting on the snow cover in this basin
means that all fluxes will be important at some point during the accumulation process. This is an excellent context for testing
an energy balance model because of the widely diverse situations occurring at this location during the same time period. In
order to calibrate the model, it was necessary to remove the stability-correction factors for non-adiabatic temperature gradients
of the turbulent transfer, which are important for evaporation. The sensible heat transfer coefficient in windless conditions is
raised to 6W/m2 · K. An empirical relationship for atmospheric emissivity calculation is derived from the observed relative
humidity, as the well-known Brutsaert’s formula clearly underestimated this value under cloudy skies.