Non-cohesive and cohesive sediment transport due to tidal currents and sea waves: A case study

Abstract

A model is proposed to determine the sediment transport rate generated by the combined action of sea waves and tidal currents, the latter being modelled as a sequence of steady currents because of the large values of the Keulegan- Carpenter number of the tidal flows, which allow to neglect inertial effects in their modelling. The hydrodynamic module solves Reynolds-averaged momentum equations by introducing a two-equation turbulence model, which considers also the flow in the region closest to the sea bottom and enforces the no-slip condition and the vanishing of the turbulent kinetic energy at the bottom without the need to assume the existence of a logarithmic velocity profile and to fiX the normal derivative of the turbulent kinetic energy close to the sea bed. Hence, the evaluation of the velocity profile in the near-bed region turns out to be accurate. The sediment transport module determines the sediment concentration and sediment transport for a miXture of non-cohesive and cohesive sediments. To validate the model, its predictions are compared with laboratory measurements and field data collected over rippled beds at two different tidal estuaries. Then, results are obtained for values of the parameters chosen to mimic a site close to Punta Umbría (Huelva, Spain) and considering different hydrodynamic conditions and different sediment miXtures. The influence of the waves on the suspended sediment concentration is lower for the cohesive fraction than for the non-cohesive fraction. For all the sediment miXtures, it turns out that the cohesive fraction is well miXed over the whole water depth, meanwhile the concentration of the non-cohesive fraction has significant values only near the bottom, thus showing that an accurate description of turbulence dynamics in the buffer layer and viscous sublayer (if it exists) is important to quantify the sediment transport rate.