Mostrar el registro sencillo del ítem

dc.contributor.authorVelasco, Jaime
dc.contributor.authorParellada Serrano, Ignacio
dc.contributor.authorMolero Jiménez, Carlos 
dc.date.accessioned2021-11-03T08:16:22Z
dc.date.available2021-11-03T08:16:22Z
dc.date.issued2021
dc.identifier.citationVelasco, J.; ParelladaSerrano, I.; Molero, C. Fully Metallic Reflectarray for the Ku-Band Based on a 3D Architecture. Electronics 2021, 10, 2648. https://doi.org/10.3390/ electronics10212648es_ES
dc.identifier.urihttp://hdl.handle.net/10481/71240
dc.description.abstractThis document presents the design and manufacture of a reflectarray (RA) antenna for the Ku-band that is based on a fully-metallic 3D architecture. The reflectarray unit cell is formed by a square-shaped waveguide section ending in a short circuit, which is the reflectarray back ground plane. Each cell has the ability of configuring the phase of its own reflected field by means of resonators perforated on the walls of the cell waveguide section. The resonator-based waveguide cell introduces the 3D character to the design. The geometry of the resonators and the size variation introduces the phase behavior of each cell, thus, conforming the radiation pattern of the reflectarray. This design explores the potential of phase value truncation (six states and two states) and demonstrates that proper pattern results can be obtained with this phase truncation.es_ES
dc.language.isoenges_ES
dc.publisherMDPIes_ES
dc.rightsAtribución 3.0 España*
dc.rights.urihttp://creativecommons.org/licenses/by/3.0/es/*
dc.subjectReflectarrayes_ES
dc.subject3D architecturees_ES
dc.subjectResonator-based waveguide cellses_ES
dc.subjectSatellite communicationses_ES
dc.subjectKu-bandes_ES
dc.titleFully Metallic Reflectarray for the Ku-Band Based on a 3D Architecturees_ES
dc.typejournal articlees_ES
dc.rights.accessRightsopen accesses_ES
dc.identifier.doi10.3390/electronics10212648


Ficheros en el ítem

[PDF]

Este ítem aparece en la(s) siguiente(s) colección(ones)

Mostrar el registro sencillo del ítem

Atribución 3.0 España
Excepto si se señala otra cosa, la licencia del ítem se describe como Atribución 3.0 España