Mineralogical, textural and physical-mechanical study of hydraulic lime mortars cured under different moisture conditions Arizzi, Anna Martínez-Huerga, G. Sebastián Pardo, Eduardo Manuel Cultrone , Giuseppe V. Mortar Curing Carbonation Calcium silicate hydrate (C-S-H) Characterization Mortero Curado Carbonatación Silicatos cálcicos hidratados (C-S-H) Caracterización This work focuses on the chemical-mineralogical, textural and physical-mechanical properties of hydraulic lime mortars made with siliceous and calcareous aggregate. Mortars were cured at 60% and 90% of relative humidity, so as to assess the variability of mortar petrophysical properties in the hardened state due to the moisture conditions. The final aim was to determine the most adequate moisture conditions to be maintained during application and hardening of hydraulic mortars intended for repair interventions. We found out that using a calcareous aggregate and curing mortar at 90% of relative humidity give place to better textural and mechanical properties. However, these characteristics mostly depend on the maximum size of the aggregate grains, which should be smaller than 6 mm, in order to avoid the occurrence of mechanical discontinuities in the mortar. En este trabajo se han estudiado las propiedades químico-mineralógicas, texturales y físico-mecánicas de morteros de cal hidráulica elaborados con áridos silíceo y calcítico. Estos morteros se han curado al 60% y 90% de humedad relativa, con el fin de evaluar las eventuales diferencias en las propiedades petrofísicas de los morteros una vez endurecidos y así establecer cuál de los dos ambientes es recomendable durante la aplicación y fraguado de morteros de cal hidráulica destinados a obras de restauración. Se ha encontrado que el uso de un árido de composición calcítica y el curado al 90% de humedad relativa dan lugar a morteros hidráulicos con mejores características texturales y propiedades mecánicas. De todas formas, estas características dependen principalmente del tamaño máximo del árido empleado, que debería ser inferior a 6 mm para evitar discontinuidades mecánicas en el mortero. 2015-06-15T13:21:11Z 2015-06-15T13:21:11Z 2015 info:eu-repo/semantics/article Arizzi, A.; et al. Mineralogical, textural and physical-mechanical study of hydraulic lime mortars cured under different moisture conditions. Materiales de Construcción, 65(318): e053 (2015). [http://hdl.handle.net/10481/36631] 0465-2746 http://hdl.handle.net/10481/36631 10.3989/mc.2015.03514 eng http://creativecommons.org/licenses/by-nc-nd/3.0/ info:eu-repo/semantics/openAccess Creative Commons Attribution-NonCommercial-NoDerivs 3.0 License Consejo Superior de Investigaciones Científicas (CSIC)